Hello,
I am integrating the Vector Com Stack (CANbedded) on to target board(RH850) with TJ1043 as transceiver.
But am not getting any interrupt except the CANerrorStatus interrupt.And this interrupt is telling there is bus off.But I ensured there is no short b/w the CAN_L and CAN_H and with Batt/GND.
It would be great if some one can give some hints to debug this issue.
Is the issue might be due to Transceiver init problem ?
Note: STB pin is writen to LOW ans EN pin is written as HIGH for transceiver.
Thanks in advance for the support.
I am integrating the Vector Com Stack (CANbedded) on to target board(RH850) with TJ1043 as transceiver.
But am not getting any interrupt except the CANerrorStatus interrupt.And this interrupt is telling there is bus off.But I ensured there is no short b/w the CAN_L and CAN_H and with Batt/GND.
It would be great if some one can give some hints to debug this issue.
Is the issue might be due to Transceiver init problem ?
Note: STB pin is writen to LOW ans EN pin is written as HIGH for transceiver.
Thanks in advance for the support.
