Hi
i change a varistor on ventilated oven hood's PCB(that located inside the hood,above the filter,inside a box)because it was damage.when the varistor burn out,it also burn out one of the conductive pathways of the PCB.the oven hood is powered by 230v through miniature circuit breaker of 16A(C).the PCB itself doesn't has a fuse.i want to solder 24 awg wires in order to pass the disconnected conductive pathway.the current that will pass through this wire is 0.4A(220v),and it will flow through the relay contacts(the relay coil controled by separated 12vdc transformer)and turn-on 2x40w bulbs.
the 24 awg wire can handle the 0.4A,but can it handle the current of a short circuit untill the MCB will operate?
thanks in advance.
i change a varistor on ventilated oven hood's PCB(that located inside the hood,above the filter,inside a box)because it was damage.when the varistor burn out,it also burn out one of the conductive pathways of the PCB.the oven hood is powered by 230v through miniature circuit breaker of 16A(C).the PCB itself doesn't has a fuse.i want to solder 24 awg wires in order to pass the disconnected conductive pathway.the current that will pass through this wire is 0.4A(220v),and it will flow through the relay contacts(the relay coil controled by separated 12vdc transformer)and turn-on 2x40w bulbs.
the 24 awg wire can handle the 0.4A,but can it handle the current of a short circuit untill the MCB will operate?
thanks in advance.