Ok, I have corrected my paths for the Mosfets, they were not according to the schematic. I'm having trouble because I'm bouncing from work and back, and such. But, it could be just to many projects at a time.
I cleaned it up a bit and you can see everything better, I'm confused why the lower Mosfet's path is different than the top? L1 and L2 are opposite in phase, shouldn't the 22ohm resistor be on the bottom of M1 and G should be connected the same as the lower Mosfet to the Coil? and if the phase inverts the voltage am I supposed to be delivering AC to the HV Primary or is it still DC? I'm a bit confused.
However, this is the new rev 4.2