AlainB
Member
Basically the regulated design is comming from the datasheet. I just add a 2200uF (C1) to reduce the ripple.
I would like to build the 5 volts supply as a module that could be add to a suitable transformer as needed.
Before making the PCB I would like to know what you think of that design and how could it be improved for maximum stability.
Thanks
Alain
I would like to build the 5 volts supply as a module that could be add to a suitable transformer as needed.
Before making the PCB I would like to know what you think of that design and how could it be improved for maximum stability.
Thanks
Alain
Last edited: