Am using the Mini-360 buck converters to provide the 5v for an arduino based project with ds18b20 sensors and driving 5v and 12v fans .
Using analogue only for a simple 4 switch resistor network
Do these little devices need any additional input or output capacitors / filtering ?
Am using the Mini-360 buck converters to provide the 5v for an arduino based project with ds18b20 sensors and driving 5v and 12v fans .
Using analogue only for a simple 4 switch resistor network
Do these little devices need any additional input or output capacitors / filtering ?
A typical post filter for any switcher is a small inductor maybe 2uH and a capacitor. The inductor should have low ESR.
An important point is that the feedback location point does not change even after adding the post filter.