First of all I hope you are using resistors in series with the LED's on the output pins. For a 5V supply and red,green, or yellow LED's I would recommend a minimum of 150 ohms.
Both counters do have 4 outputs. They are labeled Q0,Q1,Q2,and Q3. The master reset for normal operation is connected to pin 8. If you connect pin 3 to 4 and feed the output from the 555 to pin1 the output from Q3 will be 1/10 the input frequency. If you connect pin 7 to pin 1, and the 555 output to pin 4, then pin 3 will still be 1/10 the input frequency but the waveform will have equal logic 1 and logic 0 levels. Even if you are not using the CPO,CP1 and the MR pins of the other counter these pins should be connected either high(Vcc) or to GND. They should never be left floating.