ATX psu repair

Status
Not open for further replies.

JohnBG

New Member
hi, i am trying to repair old atx psu,and i need some help
**broken link removed**
**broken link removed**
it wont start, when i short green and red just clicks once.
checked 4 diodes, 2 big condesers, three primary transistors (13007), secondaru condensers(just bigger ones, marked blue), three diodes looked like transistors. tere is 310v on primary, and 5v on pin 9 is present. ic is AT2005
what can i do next? thanks
 
Try putting a minimum load of about 5 Amps on the 5 volt line. Some PSU's require a minimum load to run.
 
 
Hi,, am New to site, so am learning my around and couldn't find your response,, did the load o as prescribed work for you?
 
I cant zoom in enough, double check the areas I have arrowed for shorts. Its hard to tell from the pic you posted, but I can see possible shorts?? Could just be the pic, but worth a check, some atx need the stable wire connected as well, and a small load on all rails, normally the older types.

Some just never work again.............

 
Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…