Continue to Site

Welcome to our site!

Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

  • Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

Are interfaces based on IEEE 1596.3-1996 required to have the ability to detect bus off ?

Status
Not open for further replies.

jani12

Member
Our embedded controller is based on Renesas RH850 / U2A16 Microcontroller. Our controller has Two of these microcontrollers. The Two microcontrollers communicate with each other over full-duplex Renesas High Speed Serial Interface(RHSIF). This interface is based on IEEE 1596.3-1996 reduced range link LVDS IOs.
Is this interface required to have the ability to detect bus off? Bus off could happen due to a physical disconnect of the RHSIF wires or if the wires were shorted to each other or shorted to ground or Vcc.
 
Status
Not open for further replies.

Latest threads

New Articles From Microcontroller Tips

Back
Top