I'm sure this has allready been mentioned.
I can program my arduino once via usb, then it doesnt want to know again, if i then program it using an isp that uses the reset line I can program the bootloader and I get get another one time program.
After researching a little on line I found some posts about a reset problem on the target board, but no specific info.
If I hold reset on the 'duino, click program in the ide then let go of the reset button when the ide goes to 'programming' it works every time for as many times as I like.
I'll do this for now, but its there a more permanent solution?
I can program my arduino once via usb, then it doesnt want to know again, if i then program it using an isp that uses the reset line I can program the bootloader and I get get another one time program.
After researching a little on line I found some posts about a reset problem on the target board, but no specific info.
If I hold reset on the 'duino, click program in the ide then let go of the reset button when the ide goes to 'programming' it works every time for as many times as I like.
I'll do this for now, but its there a more permanent solution?