Alright so I just looked at my post and realized that it looks a bit rookish (Hence 0 replies). I understand all the hardware/signal transfer behind adc and dac conversions, but I'm not sure how to write the C in codevision. The code for the adc I believe is
var = read_adc(whatever portA pin I want to use)
I guess what I want to know is how (SW'wise) I take 'var' and output it serially, with some given DAC output selection bits attached (e.g. 000 attached as the MSB's selects output A of my DAC chip), so I can reconvert it back to analog. Sorry, the reason I'm having trouble with this is because I'm used to ye ol' vhdl/verilog (basically logic coding) and have only ever worked with limited C. I have to use the ATmega32 for this project, so if ya'll have any advice for me let me know, but if not I'll figure it out .
~Sean