ADC Interrupt vector.

Status
Not open for further replies.
A

alphadog

Banned
Hello,
I have a CC2430 MCU, and i'm using IAR development environment.

According to CC2430 datasheet, when an ADC interrupt occurs, then the MCU jumps to address 0x0B.
I want to build a function in code, and then make its address to be 0x0B.

How is it possible?

Thank you.
 
The compiler documentation should provide an example.

If you can not figure it out post a link to a online copy of the compiler manual.

3v0
 
The first link is to the IAR IDE users manual. It is not what we are looking for but it has a clue.

7 Absolute Placement of Code and Variables
This chapter shows how to place code and variables at absolute addresses, and the chapter is mainly intended for the CC2430. For an extended description please refer to the IAR user manual.
Click to expand...

I am guessing the IAR user manual is the compiler manual and will contain the info/example on setting up interrupts. Can you provide a link to it.

3v0
 
Status
Not open for further replies.

Similar threads

M
  • Question
TM4C1294 UART interrupt handler registration
Replies
2
Views
3K
allone
A
P
Trying to setup a 125uS interrupt.
Replies
1
Views
3K
rjenkinsgb
B
I2C, ADC, LCD, pic18f258
Replies
14
Views
2K
Ian Rogers
A
Problem comparing ADC value in assembly
Replies
1
Views
1K
Diver300
D
A
PIC ADC scaling/conversion help please
2 3
Replies
41
Views
6K
Pommie
P
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…