pls, how can I access the configuration word of a PIC16f84a so as to select xtal or resonator for the oscillator operation.
After the failure of my PIC16f628, I tried to try my codes(chasing leds- Nigel tuttorials) on PIC16f84a. The programmer tells me that the programming is ok but when I put my IC into the circuit, it just does not respond( no LED comes on)
i suspect that I've not selected the right oscillator
My tutorial source code includes the correct oscillator settings for the 16F628, you would need to change them for a 16F84.
You could do this either in the source code, or during programming via your programmer software - this should allow you to set the config fuses before you blow the chip.