Continue to Site

Welcome to our site!

Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

  • Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

A Few Questions Abount Short Wave Radio Receiving And Receivers

Status
Not open for further replies.
This one just popped up in VK7.
**broken link removed**

For the ~$30 postage to usa, this would be worth the effort. Not to forget changing the switch on the back (or internal jumper) from 240V to 110V.
 
Quite honestly, I use both Degen DE1103 and Sony SW7600GR. Well satisfied with the performance of both but the later one costs triple or more than the first one. 1103 is really a fun to tune in to. Go through eHam.net for some nice reviews on them.
 
For shortwave receivers, performance in order of importance is:

1) dynamic range - without good large signal handling performance you end up with an intermod spagetti bundle.
2) dynamic range
3) selectivity - assuming you havn't lost it with intermod you then have to pick out signal you want against potential large signals on nearby freqs.
4) sensitivity - not that important due to abundance of large signals and atmospheric noise that raise the noise floor on the receiver. Anything better then 8db to 10 db noise figure won't give you performance improvement, and likely be sacrificing dynamic range to get improved noise figure.
 
Last edited:
Quite honestly, I use both Degen DE1103 and Sony SW7600GR. Well satisfied with the performance of both but the later one costs triple or more than the first one. 1103 is really a fun to tune in to. Go through eHam.net for some nice reviews on them.

That's a bit of an antique Sony, they were pretty good for their time - but it's 30 years or so ago :D

It was also just a consumer product, not a professional or radio ham receiver.
 
That's a bit of an antique Sony, they were pretty good for their time - but it's 30 years or so ago :D

It was also just a consumer product, not a professional or radio ham receiver.

That's right Nigel, Sony thing is quite old though it's still on good production and demand. Both the models are quite good at SW/MW/FM reception except ham bands. Also I've taken MrAl's post as a newcomer into SWL :D

Anyway those professional one's are quite better on ham bands yes, much costlier too.
 
SWL receiver

HELLO MrAl:See: CQ Radio Amateur 310 (spanish) a very good receiver by Charles Kitchin.
 
Status
Not open for further replies.

Latest threads

New Articles From Microcontroller Tips

Back
Top