Hi, could anyone please tell me where i am going wrong. I am trying to program a PIC16F737 to have an internal 8MHz clock, when i use the config command i get an error saying "ERROR[126] Argument out of range (not a valid config register address)" when i build. The code is:
I have tried using the binary value too (b'11011110010000') but get the same error. Has anybody ever had this problem? I tried using the configuration bits window, however when i began to program the chip a warning comes up saying that the configuration settings have not been updated, proceed with previous configuration, can anybody tell me how to update these settings?
Thanks!
Code:
__config 0x3790I have tried using the binary value too (b'11011110010000') but get the same error. Has anybody ever had this problem? I tried using the configuration bits window, however when i began to program the chip a warning comes up saying that the configuration settings have not been updated, proceed with previous configuration, can anybody tell me how to update these settings?
Thanks!