4 Inputs & 4 Outputs

Status
Not open for further replies.
S

Suraj143

Active Member
I have 4 inputs.Also I have 4 output relays.What I need is

When input 1 is switched on relay 1 should turn on.
When input 2 is switched on relay 2 should turn on.
When input 3 is switched on relay 3 should turn on.
When input 4 is switched on relay 4 should turn on.

When input 1 & 2 is switched on relay 1 & 2 should turn on one after the other.
When input 1 & 2 & 3 is switched on relay 1 & 2 & 3 should turn on one after the other.
When input 1 & 2 & 3 & 4 is switched on relay 1 & 2 & 3 & 4 should turn on one after the other.

I want to do this without a uC.
 
hi Suraj,
What is the time gap should turn on one after the other.
 
Is it ok if the delay occurs when you energize just one switch, e.g. if you operate only switch 4, there will be a 4-second delay until relay 4 is energized?
 
It must use the same delay.This is used for a camera switcher.It has 4 cameras.I need to show them one after the other by reading the 4 input switches.

I know this is a hard circuit.
 
Are you saying the relays should switch sequentially? So, if switches 1,3 & 4 are on then the corresponding relays should each come on in sequence for one second?

Mike.
 
Last edited:
Status
Not open for further replies.

Similar threads

D
  • Question
Simple 4-20ma Current loop RF TX RX
Replies
9
Views
2K
rjenkinsgb
L
  • Question
Multiple Voltage inputs for Digital Input pins
Replies
6
Views
1K
schmitt trigger
S
T
  • Question
4029 and 4511, 2 digit up down counter
Replies
1
Views
649
sarahMCML
S
S
  • Question
Wiring 74HC595 Buttons + Teensy 4.1
Replies
13
Views
2K
rjenkinsgb
S
  • Question
Cant get touch working on ILI9341 display with Teensy 4.1
Replies
8
Views
2K
Salchicha
S
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…