SoundComposer
New Member
Hi!
I have a field mixer which I have to syncronize with the gain in my camera, but the output on the mixer is to loud - so I need to dampen it by 10 or 20 dB before going into the camera. A technician guy at an audio department gave me a quick hand written diagram how to make a simple 20 dB CUT. It's supposed to go from one stereo-minijack to another stereo-minijack. But when I came home I saw the drawing lacks a connection from the third part of the minijack on the incoming signal...
Could someone please look at my drawing (I made it myself in photoshop so don't laugh...) and tell me where I should connect the third part of the minijack?
**broken link removed**
Also, if anyone could check that this is right. Or if you have a better solution please bid in!! The technician who made the drawing wasn't totally sure, if this was the way to go.
Thanks in advance!!
Toni
I have a field mixer which I have to syncronize with the gain in my camera, but the output on the mixer is to loud - so I need to dampen it by 10 or 20 dB before going into the camera. A technician guy at an audio department gave me a quick hand written diagram how to make a simple 20 dB CUT. It's supposed to go from one stereo-minijack to another stereo-minijack. But when I came home I saw the drawing lacks a connection from the third part of the minijack on the incoming signal...
Could someone please look at my drawing (I made it myself in photoshop so don't laugh...) and tell me where I should connect the third part of the minijack?
**broken link removed**
Also, if anyone could check that this is right. Or if you have a better solution please bid in!! The technician who made the drawing wasn't totally sure, if this was the way to go.
Thanks in advance!!
Toni
Last edited: