hello every one
I'm using stm32f101vbt6 by st-linkv2 programmer.
after few times programming my micro i get this message : no target connected. so my debugger can't recognize microcontroller.
i checked every connection and it was ok I tried j-link programmer but j-link couldn't recognize micro...
hi everyone
I'm using stm32F103RBT6 and st-link v2 programmer and keil 5.
when i want to program micro i have Could not stop Cortex-M device! Please check the JTAG cable error.
in my board I did not have this error and I programmed micro without any problems. this error suddenly appeared and...