Hi, we’re running a 12v fridge off 3 leisure batteries connected to solar power. Though the fridge worked fine for the first week on solar charge, it’s now cutting out whenever we plug it in. It starts for 5 sec then shows error message ‘Not enough voltage’ - however, as per the manual the...
Hello all,
First off: let me apologise for my ignorance, this is all new to me.. :wideyed:
Recently I bought a set of a 10W solar panel with a 12V 6800MaH battery pack on Ebay advertised as being 'all you need' for a simple solar set up.
The battery pack is protected with an over charge...
I am putting together a small solar charge controller, 5w 12v panel 12v 7ah lead gel battery , circuit is similar to the one used here
https://www.instructables.com/id/ARDUINO-SOLAR-CHARGE-CONTROLLER-Version-20/
I am using a PIC24FV32KA302 ( not Arduino) the basic prototype works OK , but it...
Hello everyone. I am doing a project in which I use a buck converter to convert high vtg to low vtg.
Actually the input to the buck converter is from a solar panel which puts out 560 mA constant current and 34 V.
And output is a 12V lead acid battery. The N- Channel mosfet is used at high side...