Continue to Site

Welcome to our site!

Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

  • Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

output

  1. C

    Output Issue with LMX2594 Serial Data

    In our RF LNB, three LMX2594 RF synthesizers are connected to the Microcontroller SPI Bus. All three LMX2594 chips share the SPI CLK, MISO and MOSI lines (called SCK, MUXout and SDI in the datasheet). Each LMX2594 device has its Chip Select signal from the microcontroller (CSB). We can read and...
  2. mading2018

    Half-bridge DC/DC converter

    I am trying to simulate a half-bridge DC/DC converter, and I would like to increase the output voltage to at least 320 V. Do you have some suggestion on how to do that?
  3. mading2018

    DC/DC converter - change the output current?

    I think the output current I get from the DC/DC converter is way too low, it should be at least 6-8 A, not in mA that I got. I think the resistor that I have in the end of the converter is needed in order to obtain 400 V. Do anyone have any suggestion what could be the problem? I found a...
  4. J

    How to modify a toroidal transformer windings?

    I have a toroidal transformer which has one input of 220 Volts AC, and 2 secondary outputs of 40 volts AC each one. I want to modify it to have two 220 volts outputs instead the two 40 volts outputs that it has at the moment. I would assume that it's a very easy task and I have just to modify...

Latest threads

New Articles From Microcontroller Tips

Top