Hi,
I have motor, motor control board and optical encoder being operated through a myRIO. I have the encoder configured to read in RPM on LabVIEW and I am using a digital potentiometer to change the speed of the motor through the PC.
My problem is that the motor will work as normal when the...
Hi,
I wish to replace a mechanical potentiometer on a motor control board which is used to control the speed of a motor with a digital potentiometer. This will allow me to control the speed of the motor using LabVIEW on a PC. I have a myRIO 1900 series.
I am looking for some help with the...
Hi,
I am looking for help with the wiring involved with controlling the speed of a motor on LabVIEW through a PC rather than changing it manually on my motor control card. I currently have the motor running in both CW and ACW directions using LabVIEW.
I know I must desolder the potentiometers...
Hi,
I am looking for help with wiring a Hengstler Incremental Encoder to a National Instruments myRIO and a power source as part of a university project. The NI myRIO will be connected back to a PC using USB. The LabVIEW program will be used to to initially count the pulses/sec and then in turn...