There are four HDDs of the old IDE standard I would like to extract data from. Not even sure if I would keep any of them working later, as a permanent external drive.
Is it the USB - IDE/Sata interface the way to go? The one including an additional power supply for the drive in use.
I know I...
Hi everyone,
I am basically pretty new to the whole electronics/digital electronics thing, so please assume a pretty low level of knowledge.
I am looking to improve the interface I have between my micro-controller and Z80 SBC, which can run at 4 or 8 MHz. Currently, I am using a two-wire...
Hello,
I am working on a DIY project to interface a lot of signals to a NMEA2000 bus to be able to controle an older analog engine and other sensors with a new multi function display.
To do so I am using Arduino / Teensy microcontroller together with a NMEA2K library. I started to design the...
Recently I have been looking at driving cheap and simple 320 pix by 240 pix graphics displays with Arduino Meggas and Raspberry Pi Zeros and I noticed Nigel's comment:
@ https://www.electro-tech-online.com/threads/remote-green-house-monitor-pic-and-hc-12.149016/
Is it problematic: views...
Hi everyone,
I'm starting a new project in which I want to create multiple games inside one room. Those games will use electronics and mechanics. So for almost everyone of this games I'll need to have a monitor and a microcontroller. Besides that i'll have a main pc interfacing with the...