Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Why don't you just tell me why that is a bad idea. A 15 gallon tank should hold 15 gallons. If the pump shuts off at 14 gallons then that is the fault of the pump not the tank. So many of those nozzles add so much air to the fuel stream that they shut off way too early. Pump more slowly and...
At least around here, the gas pumps shut off well before the tank is actually full. I spend a few extra minutes nursing the pump to get that extra 1 - 1.5 gallons into the tank.
In my experience, the best resistor to use in a high pulsed power application, is a 'Cement' resistor. https://www.digikey.com/en/products/filter/through-hole-resistors/53?s=N4IgTCBcDaIMYFMC2CB2AXABAJwQZwEs90B7bEAXQF8g
Trying to drive an 8 ohm speaker directly with the output of a small signal transistor? Will never work. Something closer to this might do the job for you.
Assuming you are referring to what is normally called a Dim Bub Tester (DBT). If the projectors is designed for 112V, then you do not want to plug it into a 240V Line. Depending on how much the unit under test draws, and the wattage of the *incandescent* bulb used, the voltage to the UUT can...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
