Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Two things... It's his thread clearly he do what he wants with it.. Secondly, The Iron holder ISN'T PLA only the little tip holder.
Your obvious distain for this forum member is very apparent, please refrain from commenting, I have asked a couple of times. I shall not ask again.
Same age.. My son uses AI to draw all his pictures for the books he writes.. All in all , it does a good job. But having said that! Its a good job I'm pretty good with Gimp!! So I can fix the lil issues. LOL.
Burt! Don't get me wrong. You can do what ever you like.. But if someone does your homework, how will you know for definite, how every thing works..
Assume what we learn here.. Many Many newbe's ask "Can you do it for me" and we always say. You'll never learn if we do it for you. We are...
As I said many times... AI can only do so much.. If there is no code out there in WWW land, it cannot do much to help.
As someone who will NEVER use it I may be biased...
I reckon this could be Ideal candidate for the Pi Pico as that has programmable core pin outputs.
Pico's can be programmed in the arduino environment and are around £5
And if you like basic.. Well the MM basic is bluddy good.. Check Geoff's page https://geoffg.net/picomite.html
LOL.. He has...
When I first looked at the code The CLC out is multiplexed, when its a one the clock is the high at 637 ( which is a bit too small) and the low is derived from the CCP .. But the SDO is in gate 2 and gate 4 but the CLCPOLCON was set to gate 4.. I set it to gate 2 ( same as the coments ) maybe...
Hey Burt... My setup is stuck at 8Mhz (32 / 4 ) so the base is 8 and not 16 So I am also running too slow.
I'm going to keep going as I know I'll get it soon. The OSCCON 1 and 2 confuse me right now. but I'll get there.
The minefield of Timer 2 is bad enough as I'm not getting 1.25uS on...
You need 800khz 0.8us and .035us for a 1 and 0.35us and 0.8us for a 0.. +- 150ns total 1.25us for the period.
The B versions need a 300us rest, but the A needs a 50us rest..
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
