Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Measurement already done when running normal, if you read what I wrote the main issue is actually the lack of ability to provoke the fault at will. If the fault occur, and I then open it up for test - the heat gun operate normally and thus cannot be tested.
See the picture attached to the first...
Yes, that sounds likely as both settings are affected.
In practice this means the heat gun in practice are non-repairable as opening the heater require cutting/breaking off the plates being kind of popped in place.
Ok, maybe I try to open the heater tomorrow. Anyway, this is how the internal wiring is done inside - but without details of the heater, it ain't very useful.
Hi. I have this simple hot air gun that have a fault where the blower motor suddenly runs slower mid operation for no obvious reason.
Disclaimer: When I describe the loss in power and try to put a number on it (i.e. half power) - this is only due to audible sound, vibrations etc. that can be...
The term might differ depending on the software used. For Inkscape (a vector graphics editor, not kind of CAD software) this workflow will then be using the boolean operator Subtract.
Disclaimer: I haven't any usable experience with PCB software for this particular issue.
But - if there is PCB software out there, or PCB manufacturers that accept .svg filer or PDF files, I can propose a non-standard solution.
A drawing software called Inkscape should be perfect in order to...
Can you at least figure what the circuit boards purpose ave being ?
Do you have reasons to think the LED's may have being used to detect light rather than emitting light ?
The one thing about those cables is the waste number of cords, make them way more prone to short on the terminal (because the one thin that you didn't saw) - screw terminals are the worst in my opinion.
So, I'd say the answer really depends on the kind of terminal you put the cable into.
You...
Ok, so you do have dynamic assigned IP address.
But good news, it's probably nothing wrong with the connection itself because the network adapter has already got IP address, and that requires a physical connection being established.
The next thing you can try out is to disable IPv6, it's very...
Ok, we can probably do easier - assuming you have Cinnamon desktop (also similar for xfce) do this:
Somewhere on your menu, there should be a network symbol. Click on that symbol and bring up "Network settings".
Select "Wired" (Cinnamon specific) in menu on left side.
There may or may not be...
The hash symbol is not a part of the command, it is used to symbolize that the command is run as root. I.e. you actually write "sudo ifconfig" in the terminal, and get prompted for super user password.
Ok, what do you get from output when run # ifconfig from terminal ?
Then you can run 'nmcli con show' - if the word 'auto' shows in front of the name of the current connection (list of several connections may be visible here) then you probably have it set up to automatically receive IP address...
I assume you're talking about wired connection. Please answer the following question
What OS do you use, and what laptop model ?
In the TCP/IP settings, does your ethernet port use static IP address or automatic ?
Do you use a proper cat5e cable or some home made cable solution ?
Have you...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
