I just received my order from sparkfun yesterday, and already I think I broke it or don't have something hooked up right.
pic is a 18F452 (40 pins)
programmer is PIC-PG2C (olimex)
software is ic-prog 1.05C
hex file is blinkin.hex from sparkfun
programming tried on two computers. also tried two different serial cables.
home brewed athlon xp 3200, windows xp (yep, have the icprog.sys configured)
ancient toshiba "transportable computer", 486/dx2 66mHz, windows 98
under windowsxp icprog would throw a gear unless I selected windows api on the hardware config screen.
i tried both direct io and windows api under windows 98
i've tried every IO Delay between 1 and 10
I've tried with and without the "enable Vcc Control for JDM" option
I have 2x 452's, cannot program either.
i've observed careful ESD precautions, and its very humid here today, so I dont think anything got a zap
if I "write" without loading a hex file (everything is FF's), I dont get an error.
if I read, no error, but everything comes back as FF even after a (failed) hex programming (even if there was an error, shouldn't there be some data?)
I can use the erase command without an error.
every time I try to program the example hex file, the non-descript error "Verify failed at address 0000h!" comes up at the end.
I'm going to find another premade hex file and try it, but I'm sure the results will be the same
Any Thoughts?!
pic is a 18F452 (40 pins)
programmer is PIC-PG2C (olimex)
software is ic-prog 1.05C
hex file is blinkin.hex from sparkfun
programming tried on two computers. also tried two different serial cables.
home brewed athlon xp 3200, windows xp (yep, have the icprog.sys configured)
ancient toshiba "transportable computer", 486/dx2 66mHz, windows 98
under windowsxp icprog would throw a gear unless I selected windows api on the hardware config screen.
i tried both direct io and windows api under windows 98
i've tried every IO Delay between 1 and 10
I've tried with and without the "enable Vcc Control for JDM" option
I have 2x 452's, cannot program either.
i've observed careful ESD precautions, and its very humid here today, so I dont think anything got a zap
if I "write" without loading a hex file (everything is FF's), I dont get an error.
if I read, no error, but everything comes back as FF even after a (failed) hex programming (even if there was an error, shouldn't there be some data?)
I can use the erase command without an error.
every time I try to program the example hex file, the non-descript error "Verify failed at address 0000h!" comes up at the end.
I'm going to find another premade hex file and try it, but I'm sure the results will be the same
Any Thoughts?!