meowth08 Member Jun 23, 2012 #1 Hi, I had a problem in simulation. I opened the simulator. I opened Tools-Assembler. On the assembler: I wrote the program. I clicked tools and assembled the program and it indicated no error. I saved it with .asm extension file. I clicked Tools and Assemble and Load. I went back to the where I started. The .obj file is already there for simulation. I wanted a step by step simulation so I changed the settings. I simulated it and clicked for STEP but all were NOP. I have already read the "Getting Started". I followed the simulation procedure. Still, all NOP.
Hi, I had a problem in simulation. I opened the simulator. I opened Tools-Assembler. On the assembler: I wrote the program. I clicked tools and assembled the program and it indicated no error. I saved it with .asm extension file. I clicked Tools and Assemble and Load. I went back to the where I started. The .obj file is already there for simulation. I wanted a step by step simulation so I changed the settings. I simulated it and clicked for STEP but all were NOP. I have already read the "Getting Started". I followed the simulation procedure. Still, all NOP.
ericgibbs Well-Known Member Most Helpful Member Jun 23, 2012 #2 hi meo8, As a test I installed the OS Z80 trial. Used a sample program in assembly, assembled ok, makes obj, lst and hex files. Runs ok in Ultimate and Step for me.? E.
hi meo8, As a test I installed the OS Z80 trial. Used a sample program in assembly, assembled ok, makes obj, lst and hex files. Runs ok in Ultimate and Step for me.? E.
meowth08 Member Jun 24, 2012 #3 Thanks sir eric. I'll check if it generates .lst, .obj, and .hex file m8
meowth08 Member Jun 28, 2012 #4 haha.. I already figured out what went wrong.. org 8000H Last edited: Jun 28, 2012