Writing measured voltages to LCD

Hi everyone.....hope all is well with you guys.....i have designed a simple switching circuit that switches between a number of measured voltages....this then goes through a ADC circuit which converts the analog voltages to digital.....i have D0 to D7 coming out of the ADC.....the problem is i have to display the voltages on the LCD on a Proton development board version 1.0, I have no clue where to begin, as i have never done PIC programming before this......i'm using a 16F877A.....can someone please point me in the right direction.....thanks.

regards
tamil

There are full LCD and analogue tutorials on my website. The 16F877A has it's own internal A2D, no need to use an external one - and the internal one is ten bit rather than eight bit.