glossywhite
Member
Good day/morning/afternoon/evening to you
I have a Panasonic Cellphone (we call them "mobile" phones here in Blighty, haha!) which is of the type used on the old E-TACS analogue system, back around ~1988. I have been searching for HOURS to find a schematic/loom diagram which would tell me the pin-out of the simple 6 pin Molex connector on the base unit - all I want to do is power it up for fun
The molex connector is IDENTICAL to that found on modern graphics cards, so thankfully I have a plug for it... but DO NOT want toblow this beauty up, for obvious reasons.
If any help could be offered, I would be most grateful. Photos attached (handset says "EB-1119").
Thanks and God bless you
I have a Panasonic Cellphone (we call them "mobile" phones here in Blighty, haha!) which is of the type used on the old E-TACS analogue system, back around ~1988. I have been searching for HOURS to find a schematic/loom diagram which would tell me the pin-out of the simple 6 pin Molex connector on the base unit - all I want to do is power it up for fun
The molex connector is IDENTICAL to that found on modern graphics cards, so thankfully I have a plug for it... but DO NOT want toblow this beauty up, for obvious reasons.
If any help could be offered, I would be most grateful. Photos attached (handset says "EB-1119").
Thanks and God bless you
Last edited: