Using multiple power supplies on one led strip.

I

imstuee123

New Member
Hi, have 15m of ws 2182b rgbic, i want to keep in one strip and wondering if i can either use 4x 400w 24v power supplies to power it injected in each end and in 1/4 way. If so how can i do this as i know it will break it if i just put them on.
I have the esp32 and wled to control them which is setup on a buck converter 24v to usb 2amp which powers the esp32.

Can i also have the esp32 on a separate power supply, not sure because of the grounds and the data to the ic chips.
 
Sort by date Sort by votes
24v for WS2812 chips? No. These are 5v chips so you'll need buck converters for the LED strips too.

Also, connect the ground of all chips, power supply and ESP32 together. Separate the Vcc of the LED strip segments for each power supply so the Vcc of each supply are not directly connected.
 
Upvote 0 Downvote
If the power rail is contiguous thru all strips only if the power supplies support
load sharing will that work. If isolated then will work. Still there are considerations
for power up synchronous like timing, or delay and reinitialize strip once all power
is up and running. And you have to consult 2812 sensitivity to latchup when its
power rail not in spec while data coming to it from an earlier active strip is in spec
and can possibly cause latchup. Consult datasheet.....
 
Upvote 0 Downvote
danadak said:
And you have to consult 2812 sensitivity to latchup when its
power rail not in spec while data coming to it from an earlier active strip is in spec
Click to expand...
Have you seen the WS2812 datasheet? I doubt any such detail is in their rudimentary datasheet (unless they've made extraordinary improvements since I last reviewed it).
 
Upvote 0 Downvote
What is the operating voltage of the LED strip? WS2812B strips are typically 5V. You cannot connect them directly to 24V power supply. Here are some references that you can check.

Control WS2812B Addressable LEDs with ESP32 and WLED

A Step-By-Step guide to control WS2812B NeoPixel Addressable LEDs with ESP32 and WLED App, wiring, example to change colors and effects.
lastminuteengineers.com

Interface a Ws2812 RGB with Raspberry Pi 4 - The Engineering Projects

Tooday, we will discuss How to Interface a Ws2812 RGB With Raspberry Pi 4, where we will design different LED patterns in python code and will implement on RPI4.
www.theengineeringprojects.com
 
Upvote 0 Downvote
You must log in or register to reply here.

Similar threads

I
  • Question
powering 2 led strip lights with 1 esp32
Replies
18
Views
591
rjenkinsgb
F
  • Question
One way to fix a damaged pickup.
Replies
1
Views
1K
ahsrabrifat
A
L
  • Question
Using 220v transformer on 120v
Replies
4
Views
2K
Lubby01
L
A
  • Question
Identifying power connectors on a USB Charging PCB
Replies
4
Views
2K
viviak
V
Z
  • Question
How to power on this weird circuit?
Replies
14
Views
3K
Zestfully4
Z
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…