I have a Tone King Falcon amplifier. I am having a very weird problem with it. The amp uses 3 12ax7 tubes, and 2 6v6 tubes. When I plug the amp into the wall and just plug a guitar straight in, it works great. However, when I plug my guitar into my pedal board and the pedal board into the amp, the amp dies temporarily. The amp does not take ANY input signal at all when this happens. Even if I turn it all the way up and touch the input cable, no buzz comes out or anything. HOWEVER, if I touch the cable to any of my pedals, I get sound--just a buzz, but a sound, nonetheless. I have replaced the tubes and tried different speakers, and all different cables, but the problem persists. Oddly enough, if I leave the amp alone on standby, it starts working again after 25 minutes or so. When it "comes to life," it works great, but as soon as I touch that input cable to my pedals again, it dies. When it "dies," the tubes all light up still, and the amp appears to be functioning fine, but it will not amplify ANY input signal at all except for the buzz I get if I touch the cable to my pedals
I have 5 seperate pedals on my board, and each is powered by a single adapter that branches into 5 different outputs for the pedals. There is one pedal that takes a different adapter, so that is powered with a different adapter. both of those adapters are fed by an extensinon cord that is connected to a Furman Power conditioner, which is plugged directly into the wall. The amp is also plugged straight into the Furman.
WHAT IS GOING ON HERE???? Please help.
I have 5 seperate pedals on my board, and each is powered by a single adapter that branches into 5 different outputs for the pedals. There is one pedal that takes a different adapter, so that is powered with a different adapter. both of those adapters are fed by an extensinon cord that is connected to a Furman Power conditioner, which is plugged directly into the wall. The amp is also plugged straight into the Furman.
WHAT IS GOING ON HERE???? Please help.