Syntax Error with PBP and Mplab

I got a Syntax Error on line 26 of this code. Line 26 is SF=0
SF should be BUZ. if I change it to buz and try compiling
I get unable to access file
Error processing cod file
if I change it back to SF I get the line 26 error. any help

SYMBOL TRG = GPIO.0
SYMBOL Camswitch = GPIO.1
SYMBOL SENSOR = GPIO.2
SYMBOL BUZ = GPIO.5


TRG= 1
Camswitch = 0
SF=0

You've already assigned BUZ to a port. If you are trying to make the port go low try "LOW BUZ" instead of BUZ=0.

thanks I will try that tonite. :lol:

still a nogo anyother ideals. I know its something simple but over my head

Simple
could you post all your code for review?

sorry for not getting back i had to go out of town. found the problem the code was written using CDlite I could fix it there. but not in PBP. thanks again and I'm sure I will need more help in the future