I imported a motor controller card.It can turn the motor left,right & up,down.
It has small 110V AC relays in the output.Here we need 230V AC & the motor also 230AC.
What I did is I drive another set of relays using onboard relays.
The problem is the card is giving pulses so when switching 230V contacts their is arc generating.
How to prevent this problem?
It has small 110V AC relays in the output.Here we need 230V AC & the motor also 230AC.
What I did is I drive another set of relays using onboard relays.
The problem is the card is giving pulses so when switching 230V contacts their is arc generating.
How to prevent this problem?