Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
My MSP430F2272 doesn't give any output when connected to the power supply alone. But if i attach the programmer / Debugger in the header provided, it start functioning as per expected.
The RST pin is been pulled up with 10 K resistor too.
I seem to remember having a problem like this and I think it was a power problem I had.
What programmer are you using, JTAG, or spy-by-wire? What board are you using?
All I can say is check your power input and pullup voltage with a multimeter when removing the programmer. The programmer will supply power to the board when it is attached, so the main difference is that extra power connection.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
