Z zhizhi16 New Member Apr 29, 2004 #1 Does anyone know if i can use one stepper motor driver for two stepper motors? Will it be too draining for the chip? It works for one.. i don't dare to fix another one to the same chip to see if it works. My stepper motor taken from the printer 90Ohm... unipolar
Does anyone know if i can use one stepper motor driver for two stepper motors? Will it be too draining for the chip? It works for one.. i don't dare to fix another one to the same chip to see if it works. My stepper motor taken from the printer 90Ohm... unipolar
T TillEulenspiegel New Member Apr 29, 2004 #2 Bad design practice, don't recommend it . I have seen it work, but it's not anything you want to do except for farts and grins. You don't mention the driver circuit capacity of the drain by either motor.........so Um......
Bad design practice, don't recommend it . I have seen it work, but it's not anything you want to do except for farts and grins. You don't mention the driver circuit capacity of the drain by either motor.........so Um......