Hello i am using a switch that has 3 pins and it should do start and stop
I am using built in pull up resistors and when i connect all 3 pins to the microcontroller. It freezes. When i take off one pin then it works. I have used diferent switches and all seem to do the same thing. There are 3 pins named "C" " NO" and "NC" I have no idea what those mean but when its on C and NO are continous when its off C and NC are contious or vice versa . So i guess C is common. But only C and NO works together. When i do C and NC and i reset my controller it freezes. If i take off the pin reset then place the pin back then it works. but doesnt work if its on and i reset. Any suggestions on what im doing wrong? Greattttttly appreciated.
Wood pitches next week
Prior too
I am using built in pull up resistors and when i connect all 3 pins to the microcontroller. It freezes. When i take off one pin then it works. I have used diferent switches and all seem to do the same thing. There are 3 pins named "C" " NO" and "NC" I have no idea what those mean but when its on C and NO are continous when its off C and NC are contious or vice versa . So i guess C is common. But only C and NO works together. When i do C and NC and i reset my controller it freezes. If i take off the pin reset then place the pin back then it works. but doesnt work if its on and i reset. Any suggestions on what im doing wrong? Greattttttly appreciated.
Wood pitches next week
Prior too