Soldering an Audio Jack

Status
Not open for further replies.
O

ormo

New Member
Hi,

I'm currently making an amplifier and I've come across a bit of a problem:

I need to solder a length of 4-core flex onto a 4-pole 3.5mm male audio jack. The connection points are all very small (as would be expected) and they don't take to the solder very well. Can anyone recommend any tips on how I could solder the wires on?

Should I just abandon this idea and find a different connection type with 4 poles that is easier to solder (perhaps a USB plug)?
 
I have noticed that very cheap audio jacks made in China cannot be soldered.
I have never had a problem with quality jacks made by Switchcraft in the USA.

The cheap jacks fall apart or fail soon. Switchcraft jacks are made properly and last "forever".
 
Looks like I'll look for another style of plug, any suggestions for an easy to solder plug type (I need the male and female) that has at least 4 poles?
 
4 pin mini din? there are loads about, and you can buy ready made extensions pretty easy if that helps, as thats what S-Video on the tv uses.
 
many of those connectors have a thin coating of new-silver (chemical silver) which corrodes and turns black caused by humid air.

They are not solderable anymore under these conditions.

This is how to clean them: Mix a "pudding" of water and cigarette ashes (better cigar ashes) and use a worn out toothbrush to clean the connector.

Rinse with clear water and dry immediately with a hair dryer.

Solders like a charm after treatment.

Boncuk
 
Sounds like a cheapy solder iron. Invest in a better iron, as it will make all your future projects much easier.
 
I don't think the iron is the problem - everything else solders perfectly. The solder will form around the wire and the connection point but then any amount of force on the wire and the solder itself will just pop off the plug. I'm going to use a USB Type-B plug anyway.
 
Boncuk said:
This is how to clean them: Mix a "pudding" of water and cigarette ashes (better cigar ashes) and use a worn out toothbrush to clean the connector. Rinse with clear water and dry immediately with a hair dryer. Solders like a charm after treatment.
Click to expand...

Or just use Tarn-X tarnish remover (thiourea+sulforric acid), available at many stores near you (near me). Dip it in and the tarnish disappears...
 

Connectors require more heat than standard parts. USB connectors are frail in my opinion and cheap ones are real flakey, but suit yourself. I have many years experience using irons, and I am sure your trouble with the connector is your iron. Just for giggles, or to prove me wrong, what iron are you using?
 
RadioShack doesn't buy cheap Chinese connectors. They "dumpster dive" and get defective ones (steel?) for free then sell them at inflated prices.

Get a good American jack.
 
Status
Not open for further replies.

Similar threads

F
A Cool Find – '50s/'60s Weller Soldering Gun
Replies
16
Views
1K
Doug
D
C
  • Question
Advice on Weller soldering iron tips etc.
Replies
10
Views
2K
ZipZapOuch
M
  • Question
Audio activated LEDs
Replies
14
Views
2K
Tony Stewart
D
Audio out Mod Cap?
Replies
2
Views
962
Tony Stewart
F
  • Question
PCM2903C USB Audio Codec Alternatives & Experiences
Replies
5
Views
1K
For The Popcorn
F
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…