Finally nailed it! Can't believe how simplistic it turned out to be. I wasted so much time trying to get the Config Servos command working, and failing. So, I started playing with Pulseout and some LEDs, and it just sort of clicked.
Anyway, here's the code if anyone is interested. The servo control signal comes off pin 5. Used the 4.8 Mhz internal oscilator.
Starts the servo in the center position, goes right, center, left, and repeats...
Might not be going fully to either extreme, but will be good for the project I needed servo control over.
Anyway, here's the code if anyone is interested. The servo control signal comes off pin 5. Used the 4.8 Mhz internal oscilator.
Code:
$regfile = "attiny13.dat"
$crystal = 4800000
Config Portb.0 = Output
Dim A As Word
Do
For A = 1 To 20
Pulseout Portb , 0 , 1500
Waitms 20
Next
For A = 1500 To 1000 Step -10
Pulseout Portb , 0 , A
Waitms 20
Next
For A = 1 To 20
Pulseout Portb , 0 , 1500
Waitms 20
Next
For A = 1500 To 2000 Step 10
Pulseout Portb , 0 , A
Waitms 20
Next
Loop
EndStarts the servo in the center position, goes right, center, left, and repeats...
Might not be going fully to either extreme, but will be good for the project I needed servo control over.