Servo feed pulses varies from 1mS to 2mS.If I want to turn the servo to its neutral position I need to feed 1.5mS pulse continuously.If I stop the sending pulses to the servo what will happen?
Is there any method to control the servo speed by its data line?
Another problem is servo motor has three wires 5V GND & Control.But I see in some articles some of them are reading the control line.Not outputting a signal.
Is this control line is input or output I'm confused.
If you don't send it pulses then it becomes passive (as though it is powered down), you need to send the pulse 50 times per second to make it hold position against a force. You vary the speed by altering the pulse length slowly, otherwise it will go at full speed to the desired position.
The signal wire is an input on a servo motor and an output on a receiver.