Did some further tests. Namely, I have 125 VAC on the primary of the HiV/Fil transformer. Checked the HiV cap with a megger, it reads 1 meg ohm, I'm assuming that is the bleeder resistor that is inside the 1.05 ufd capacitor. The secondary of the transformer is 100 ohms, just what the spec sheet states. As i hear no arcing, and the trannie is not getting hot, I must conclude the maggie is not emitting. As I can buy a new one for the price of a maggie, that seems to be the logical course.
Has any ham used the Hi Voltage trannie as a power trans for a home brew 40 meter rig?
As for the resistors, they were listed as Hi voltage, again how hi is up?
So I shall put this back together, and workout for an hr or so, unless someone has a great idea to try.
Thankyou one and all for the help.