Hi there!
My RB0 interrupt pin I configured as an input pin it’s an active low type.
It’s working well.
When I’m giving pulse from a 555 circuit to the RB0 do I have to configure it to rising edge or falling edge on the OPTION REG, INTEDG?
By default this bit has clear.
Thanks.
My RB0 interrupt pin I configured as an input pin it’s an active low type.
It’s working well.
When I’m giving pulse from a 555 circuit to the RB0 do I have to configure it to rising edge or falling edge on the OPTION REG, INTEDG?
By default this bit has clear.
Thanks.