Ok I'm reading a datasheet for a 1N4148 Diode and its Vf is 1V. If is 10mA.
Am I right in assuming then that if I have a 1.1V Peak to Peak 440hz AC signal going through it that assuming the current was less than 10mA that it wouldn't damage it but simply cut off the current at that point? Essentially create distortion?
I'm just trying to get a grasp of electronics and the use of certain parts.
Am I right in assuming then that if I have a 1.1V Peak to Peak 440hz AC signal going through it that assuming the current was less than 10mA that it wouldn't damage it but simply cut off the current at that point? Essentially create distortion?
I'm just trying to get a grasp of electronics and the use of certain parts.