Continue to Site

Welcome to our site!

Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

  • Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

Propositional Integrator

Status
Not open for further replies.

kumar143

New Member
Hello to Every one

I design a proposition controller wid op amps.When I design a circuit according to the data sheet of Op amp (ALD1701/AL).I gave 1.005 v inputs and unity gain Inverting amplifier but I am getting only 463mv.

Please help me to sort out this problem.
Now I am uploading my circuit and data sheet of Opamp.
 

Attachments

  • propo..png
    propo..png
    12.7 KB · Views: 177
  • pro output..png
    pro output..png
    17.4 KB · Views: 139
  • ALD1701 datasheet&#46.pdf
    70.2 KB · Views: 283
The simulation is correct! Think about it. It is a MICROPOWER opamp. How much current can it source from it's out put pin??????
 
Remember, the feedback resistor is also part of the output load since it goes to a virtual ground point.
 
Status
Not open for further replies.

New Articles From Microcontroller Tips

Back
Top