Propositional Integrator

Status
Not open for further replies.
K

kumar143

New Member
Hello to Every one

I design a proposition controller wid op amps.When I design a circuit according to the data sheet of Op amp (ALD1701/AL).I gave 1.005 v inputs and unity gain Inverting amplifier but I am getting only 463mv.

Please help me to sort out this problem.
Now I am uploading my circuit and data sheet of Opamp.
 

Attachments

  • propo..png
    12.7 KB · Views: 178
  • pro output..png
    17.4 KB · Views: 141
  • ALD1701 datasheet&#46.pdf
    70.2 KB · Views: 285
The simulation is correct! Think about it. It is a MICROPOWER opamp. How much current can it source from it's out put pin??????
 
Remember, the feedback resistor is also part of the output load since it goes to a virtual ground point.
 
Status
Not open for further replies.

Similar threads

F
Inv-Amp gives poorer stability margins for SMPS? (compared to op-amp integrator)
Replies
0
Views
1K
Flyback
F
E
op amp integrator and differentiator circuit
Replies
16
Views
3K
crutschow
D
What is the Roll-Off frequency of this op-amp integrator?
Replies
1
Views
2K
MikeMl
Integrator question
Replies
18
Views
2K
Winterstone
W
D
OpAmp Integrator Circuit
Replies
5
Views
6K
crutschow
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…