programming a chip

[gugs]

hi all, first post on this site. this post concerns a 16f84a micro.i am running lastest version of ic prog. what i am looking to do, is take pre-written code and download it into a pic. how is this done? i need a detailed, step by step procedure. while i've been in the consumer electronics business for more years than i care to remember, my knowledge of computers is very limited. i am not looking to write code, rather i want to just be able to impliment it. would appreciate any comment. btw i built a jdm type programmer called multi programmer thanks

 

[Marks256]

http://www.covingtoninnovations.com/noppp/

That should allow you to do what you asked. If you want to start making your own programs, i would suggest a good high voltage programmer, and a newer PIC.

 

[gugs]

programming a micro

hi marks, thanks for your response. will check out that site.