Program from MUC

rabhishek91 · Apr 1, 2013

Hi. I have some weird doubt.
Usually we burn/transfer the program to Micro-controller.

Can this be done the other way ?

I mean can we get to know the program from Micro-controller by any means ?

Jon Wilder · Apr 1, 2013

You mean read the program from the microcontroller?

Yes and no. If the programming hardware/software is capable of reading it, and if code protection was not enabled at the time that the microcontroller was programmed, then yes you should be able to read it.

However, if the code protect was enabled at the time the micro was programmed, then you cannot read it back.

rabhishek91 · Apr 2, 2013

Jon Wilder said:
You mean read the program from the microcontroller?

Yes and no. If the programming hardware/software is capable of reading it, and if code protection was not enabled at the time that the microcontroller was programmed, then yes you should be able to read it.

However, if the code protect was enabled at the time the micro was programmed, then you cannot read it back.

Thank you sir. You have answered to the point.

Program from MUC

Can we know get to know the program if a MUC is given ?

Yes

It's a No you foolish

May be

rabhishek91

New Member

Jon Wilder

Active Member

rabhishek91

New Member

Similar threads

Program from MUC

Can we know get to know the program if a MUC is given ?

Yes

It's a No you foolish

May be

rabhishek91

New Member

Jon Wilder

Active Member

rabhishek91

New Member

Similar threads

Privacy & Transparency

Privacy & Transparency