probs with EAGLE DRU

Hi guys.

I have a board and no matter how small I set the DRU spacing between traces/pads etc..Eagle seems to complain. I went down to 1 mil for ALL DRU clearances and it still complains about clearance. It seems to be wanting 15 mil min. By zooming in and setting the grid to 1 mil I can get a reasonable measure of the clearances it's hilighting. It's even complaining about pad spacing between library SMD device pads for SOT 6 devices.

Any thoughts?

Without seeing the board and the errors it is hard to give advice.

It was the NET class default causing the prob, 3vO

Cool and glad you found it.