At this time, programming will work if PGM (RB3) is connected to the 0 volt!
If I toggle the LED with 100 mSec then I see the LED flashes, with 500Msec the LED light continuously.
If I disconnect the PGM from the 0 volt everything will stop?
Somewhere there must be something around the PGM?
Now I read the following!
To disable the Low-Voltage ICSP mode, the LVP bit must be programmed to ‘0’.
This must be done while entered in the High-Voltage Entry mode (LVP bit = ‘1’).
RB3 is now a general purpose I/O pin.
The factory default settings are LVP = '0'!
I use the Picket 3 programmer so I program with High voltage that means that LVP bit must be '1'
The question is how do I program it?
Has anyone done this before?