Hi
I am using cypress cy7c68013a-100a and driver cyusb.sys in "Cypress Suite USB 3.4.6"
for win 7 in wlh folder.
and change .inf file (my .inf is attached)
View attachment cyusb.txt
and build a board according AN15456 in this address
**broken link removed**
When I connect on some PC's running Windows 7, i see "the device is not recognized" and "this device connot start(code10)"!
I checked my hardware again and again.but i see this error yet
* i can't find 'tps3820-33' for reset pin so i use a 100k from reset pin to 3.3v and a 0.1uf to gnd *
'tps3820-33' is my problem?!!
Thanks in advance for any help you can offer
sam
I am using cypress cy7c68013a-100a and driver cyusb.sys in "Cypress Suite USB 3.4.6"
for win 7 in wlh folder.
and change .inf file (my .inf is attached)
View attachment cyusb.txt
and build a board according AN15456 in this address
**broken link removed**
When I connect on some PC's running Windows 7, i see "the device is not recognized" and "this device connot start(code10)"!
I checked my hardware again and again.but i see this error yet
* i can't find 'tps3820-33' for reset pin so i use a 100k from reset pin to 3.3v and a 0.1uf to gnd *
'tps3820-33' is my problem?!!
Thanks in advance for any help you can offer
sam