Mark (Imagine Design)
New Member
Have started a new project using a PIC16F88 on a tight budget.
Am using MPLAB 7.31 and writing in assembler.
I have attached the project in full and would like someone to look at the code as I cannot get anything to work.
As you will see the code should toggle outputs.
I am using the internal clock.
I have disconnected everything except the +5v and 0v but don't see any lines toggling.
I don't believe the CPU is running.
I am new to the PIC architecture and believe I have something basic wrong.
I am an experienced assembler programmer and 'C' programmer.
Once I have the CPU running I believe I will be OK.
I very much look forward to your help and also hopefully returning the favour when I can
Many thanks in anticipation. Mark.
Am using MPLAB 7.31 and writing in assembler.
I have attached the project in full and would like someone to look at the code as I cannot get anything to work.
As you will see the code should toggle outputs.
I am using the internal clock.
I have disconnected everything except the +5v and 0v but don't see any lines toggling.
I don't believe the CPU is running.
I am new to the PIC architecture and believe I have something basic wrong.
I am an experienced assembler programmer and 'C' programmer.
Once I have the CPU running I believe I will be OK.
I very much look forward to your help and also hopefully returning the favour when I can
Many thanks in anticipation. Mark.