hello all,
I' have buy the SLA7062M unipolar stepper motor driver/translator . I' would like to ask as about that, how can i control this chip with microcontroler-PIC.
I use the PIC16F876 and i've clock frequency 10MHz for timing. So, the instruction word is tc= 0,4 μsec. More over, i saw the picture with name "logic input timing" in datashet of SLA7062M on page 4.
could you write a simple code in assembly code which is possible to move stepper motor???
John
I' have buy the SLA7062M unipolar stepper motor driver/translator . I' would like to ask as about that, how can i control this chip with microcontroler-PIC.
I use the PIC16F876 and i've clock frequency 10MHz for timing. So, the instruction word is tc= 0,4 μsec. More over, i saw the picture with name "logic input timing" in datashet of SLA7062M on page 4.
could you write a simple code in assembly code which is possible to move stepper motor???
John
Last edited:
